One more from the lot. Savinelli one of my favorite brands, beautiful pipes, that smoke great and at a price an average Joe can afford. I have quite a few in my collection, from my more expensive Autograph 4 to my less expensive Trevi each one preforms wonderfully.
The pipe had a few issues, oxidation, chatter and the stem logo was buffed clean off. The edge of the rim towards the shank was sanded or buffed down unevenly compared to the rest of the rim. A ton of carnauba wax was used and caked in every nook and cranny. On the plus side the nomenclature is crisp and the pipe seemed pretty clean.
The use of both the PipNet and the CastleFord reamer would be used once again to ream back the cake in this smaller chambered pipe.
Next I cleaned the internals of the stem and stummel with EverClear, stiff/soft pipe cleaners, Q-Tips and makeup pads, cleaning until my final pipe cleaner came out as it went in. The internals were surprisingly clean.
The stummel was over waxed, every crevice was caked in the stuff. Using Method Wood For Good Polish, a children’s toothbrush and a straight pin I began to remove the excess wax.
I removed the little build up on the rim with Method and a Q-Tip. The rim was uneven, it looked as if the previous owner tried to remove a rim burn and left it unfinished. To even things out I sanded the higher portions of the rim with 400, 800 and 1000 grit sandpaper until I had a uniformed shape. I re-stained the rim with a light brown touch-up marker and removed the excess with a alcohol dampened rag.
The stem was heavily oxidized, I applied a generous amount of non-bleach Soft Scrub and left it aside to penetrate the oxidation. Once the Soft Scrub turns from white to a brownish color its time to scrub vigorously with a rag until the oxidation is removed, adding more Soft Scrub as needed. Holding the stem under natural light will help to see if all oxidation was removed. I tried heat to remove some of the deep tooth impressions using a Bic lighter (moving the flame at all times never leaving it in one spot to long) a few raised but a couple of stubborn deeper impressions would need filling.
I mixed thick black CA glue and charcoal powder together to fill in the deep impressions hitting it with accelerator to set the patch, I left it overnight to cure. The following morning I taped off the bit/lip area so my more abrasive sanding would remain in one area. I sanded with 400, 800 and 1000 grit sandpaper to blend the repair.
I now ran the stem though the various grits of micro-mesh pads.
I finished up on the wheel with white diamond, a few coats carnauba and a micro-fiber hand buff. Buffing the stem with blue compound and carnauba.